Trailer Hitch Covers

$7.25
Write a Review
Width:
4.70 (in)
Height:
3.40 (in)
Depth:
0.03 (in)
Adding to cart… The item has been added

Unisub® 2" Hitch Cover, Black Plastic with 4.7" x 3.4"x .030" White Gloss Sublimation Aluminum Insert. Injection-molded cover fits into the 2" square hitch receiver hole. Secured with standard hitch pin (not included).

Instructions:

Time: 60 Seconds
Temperature: 400° F   (204° Celsius)
Pressure: Medium

Hover transfer under open heat press for 10 seconds to dry excess moisture.

1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using ProSpray or Heat Tape.
3. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.

NOTE:  Be sure to remove the protective plastic covering before applying transfer.