null Skip to main content

Sublimatable Polar Camel 30 oz. White Vacuum Insulated Tumbler w/Lid

$14.00
Write a Review

IN A CONVECTION OVEN (With SHRINK WRAP)
Supplies needed:
- sublimatable substrate (polar camel)
- sublimation transfer
- shrink wrap
- heat gun (to pre-shrink the shrink wrap)
- heat tape
- convection oven

Oven settings:
- temperature - 375-380 degrees F
- dwell time - 5 to 6 minutes

STEPS:

1. Position transfer onto the substrate using heat tape to secure the transfer
to the substrate.
2. Place tumbler into the shrink wrap.
3. Using the heat gun carefully direct hot air all over shrink wrap until it
conforms to the tumbler
4. Place Polar Camel in oven with recommended settings listed above.
5. Pull from oven and remove wrap and paper. Caution contents will be hot
use heat resistant gloves for safety.

Tips:
- If the image of the final product appears light increase the pressure or
the dwell time slightly (30-45 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed or has brown spots reduce the dwell time slightly (30-45 seconds).

IN A CONVECTION OVEN (with SILICONE WRAP)
Supplies needed:
- sublimatable substrate (polar camel)
- sublimation transfer
- scratch paper
- Silicone Wrap (MGWRP6)
- heat tape
- convection oven

Oven settings:
- temperature - 380-400 degrees F
- dwell time - 6 to 7 minutes
- pressure - light to medium

STEPS:

1. Position transfer onto the substrate using heat tape to secure the transfer
to the substrate.
2. Cut a piece of scratch paper to tape over your artwork transfer this
protects your wrap from ink.
3. Use the silicone wrap to secure the transfer to the Polar Camel start
wrapping the Polar Camel by stretching and rolling the silicone over top of
itself. Make sure to start wrap in a non artwork area to prevent a line in
your artwork.
4. Put a piece of heat tape around silicone wrapped Polar Camel to secure
wrap.
5. Place Polar Camel in oven with recommended settings listed above.
6. Pull from oven and remove wrap and paper. Caution contents will be hot
use heat resistant gloves for safety.

Tips:
- If the image of the final product appears light increase the pressure or
the dwell time slightly (30-45 seconds).
- If the image on the final product appears blurred or substrate appears
yellowed or has brown spots reduce the dwell time slightly (30-45 seconds).
- Too much pressure can cause trapped moisture in the paper to "jet" away
pulling ink with it in a spiked-peaked formation. To avoid this reduce the
pressure.